How do I program my Elite 5600 water softener?
1. Push and hold for 5 seconds both the Up and down Set Buttons to enter Programming Mode. 2. Push the Extra Cycle Button once per display until all have been viewed and this mode is exited and normal operation is resumed.
How long does a fleck 5600 take to regenerate?
about 90 minutes
After the backwash stage, salt brine automatically drawn in from the brine tank and slowly rinses through the softening resin for 1 hour, which allows the hardness minerals to be swapped out with harmless sodium or potassium ions. This entire automatic process, called ‘regeneration’ takes about 90 minutes.
How many gallons of water does a water softener use during regeneration?
35 to 65 gallons
During recharge (regeneration), it uses approximately 35 to 65 gallons of water, depending on the size of the water softener. While going through regeneration, the motor will not run constantly, it will go through several starts and stops.
Is the Fleck 5600 SXT ready for service?
Installer manual Fleck 5600 SXT – Commissioning Ref. MKT-IM-013 / E – 23.09.2020 67 / 104 The system is ready and in service. 7.2Sanitization 7.2.1Disinfection of water softeners The materials of construction of the modern water softener will not support bacterial growth, nor will these materials contaminate a water supply.
When to install a bypass valve on a Fleck 5600?
Installer manual Fleck 5600 SXT – Installation 48 / 104 Ref. MKT-IM-013 / E – 23.09.2020 5.9Bypassing A bypass valve system should be installed on all water conditioning systems. Bypass valves isolate the softener from the water system and allow unconditioned water to be used.
How to clean the Fleck 5600 SXT injectors?
Installer manual Fleck 5600 SXT – Maintenance 84 / 104 Ref. MKT-IM-013 / E – 23.09.2020 9.4.7Injector cleaning 1. Using a flat screwdriver or an 8 mm wrench, remove the screws (6). 2. Remove the cap injector (5). 3. Remove the seal (4). 4. Remove the filter (2). 5. Using a flat screwdriver, remove the injector nozzle (3). 6.
What does the X1000 indicator mean on the Fleck 5600?
x1000 indicator• Appears when the displayed number is bigger than 9999. Installer manual Fleck 5600 SXT – Programming 54 / 104 Ref. MKT-IM-013 / E – 23.09.2020 8. Programming icon • Appears in programming modes. 6.2Commands Info Menus are displayed in a defined and incremental order.