What is Arduino weather station?

This is the first generation of my Arduino based mini-weather station with Wi-Fi connection, which is able to post data publicly online using the ThingSpeak platform. The weather station collects the following data related to the weather and environment using different sensors: Temperature.

How do you build a weather station?

Procedure

Have an adult punch a hole in the side of the bottle about an inch from the bottom.
Cut the tips off the shoestring.
Cut a small piece of packing tape.
Push the shoelace through the hole.
Wait five to 10 minutes, and read both thermometers.
Keep a record of the daily humidity for a few weeks.

How do I make an Arduino wireless weather station?

Table of contents

Arduino Wireless Weather Station.
Step 1: Get All the Parts.
Step 2: Temperature and Humidity Sensor – DHT22.
Step 3: The DS3231 Real Time Clock Module.
Step 4: NRF24L01+: Wireless Modules.
Step 5: Building the Trasmitter.
Step 6: Building the Receiver.
Step 7: The Transmitter Code.

How do I make an Arduino weather station?

About this project

Step 1: About DHT11 Sensor. DHT11 is a humidity and temperature sensor.
Step 2: Connecting DHT11 With Arduino.
Step 3: I2C LCD Display.
Step 4: Connecting I2C LCD Display to Arduino.
Step 5: Code.
Step 6: Complete Construction and Working.
Step 7: Sponsor by NEXTPCB.
Step 8: NextPCB Offers.

How do you use a weather station?

Weather Station Installation Place your thermometer and humidity sensors at eye level, roughly six feet off the ground. Your anemometer and wind vane should be in an unobstructed area and as high as possible. Official readings are taken at 33 feet. Place your rain gauge at least 4-6 feet off the ground.

How do I connect Arduino to temperature sensor?

Connecting DS18B20 With Arduino

Connect the GND pin or the black wire of the sensor to the GND.
Connect the Vcc pin or the Red wire of the sensor to the 5V supply.
Connect the signal pin or the yellow wire to the 5V through a 4.7kohm resistor and also connect this signal pin to the Digital Pin no-12 of Arduino.

How do I set up a weather station using Arduino Uno?

Before upload code into your Arduino Uno register in wunderground.com to obtain a WU station ID and key/password 2. Change this ID and key/password into your weather station Arduino code. char ID [] = “xxxxxxxx”; //wunderground weather station ID 3. Change altitudepws to get relative pressure meters (m)

Can my Arduino Mini weather station post data publicly online?

This is the first generation of my Arduino based mini-weather station with Wi-Fi connection, which is able to post data publicly online. This is the first generation of my Arduino based mini-weather station with Wi-Fi connection, which is able to post data publicly online using the ThingSpeak platform.

What is the Arduino Uno?

The Arduino UNO is the most widely used board for developing Arduino projects. Although it doesn’t require much power to operate, it is not the most energy- efficient Arduino board.