Why is my PetSafe cat flap flashing red?

Why is my PetSafe cat flap flashing red?

Error N/A Red – Continuous quick flashing Remove batteries, wait 30 seconds then replace batteries. If Red light continues, contact the Customer Care Centre. Latch will attempt to unlock for cat flap to be used in Manual Mode.

Why is my PetSafe cat flap not working?

The sensor, which scans your pet’s microchip, might need a reset. This can take up to 10 seconds. If it happens occasionally, then it should not be a cause for concern. But if it starts happening frequently, then you should inspect the tunnel to ensure that the tunnel and lenses are free from dirt.

How do you reset a cat’s cat flap?

Factory Reset To erase all programmed I.D. Discs / microchips, press and hold the ‘PROGRAM’ button for 30 seconds until LED flashes. After a further 30 seconds you may re-programme I.D.

Why is my SureFlap hub flashing red?

If both the ears on your Hub are flashing red it means it has lost connection with a Pet Door. pressing the button on the base of your Hub for 10 seconds.

How do you reset a SureFlap pet door?

Answer

1. Remove the battery cover lid.
2. Press and hold the memory button for at least 10 seconds.
3. The indicator lamp will stay on for the duration that the button is held down.
4. When the memory is wiped, the catch will open and close automatically.
5. Let go of the memory button and replace the battery cover lid.

Why is my cat scared of the cat flap?

Others will leave through the flap without problem but cry for you to let them back inside. Cats avoid cat flaps due to confusion, assuming it’ll be dangerous on the other side or that the flap will be too heavy to push open. Other cats dislike the sound of the locking mechanism or plastic flaps.

Why is my SureFlap cat flap flashing?

How to tell if the batteries need replacing on the SureFlap Microchip Cat Flap. If the LED light starts flashing red every five seconds, this is an indicator that you need to replace the batteries.

Which cat flaps are suitable for my door or partition?

All PetSafe®Microchip Cat Flaps are suitable to fit any door or partition although additional materials and competent DIY skills may be required. Note: This Cat Flap is designed as a retrofit for PetSafe®300, 400, 500 and 900 series Cat Flaps.

How do I install batteries in my petporte smart flap®?

When the Petporte smart flap®is operating under battery-mode ONLY, it will scan for the cat’s microchip only AFTER the cat has pressed against the flap, thus getting the battery out of sleep-mode. To install batteries, remove the small cover plate with a screw driver and attach a 9-volt (IEC 6LR61) battery to the connecting snaps.

Will my petporte smart flap® work with my Cat?

We strongly recommend that your Petporte smart flap®is assembled, powered up and programmed for your cat and a check made that it works with the microchip in your cat first. Installation in a Metal Door:Prior to installation it is recommended to check if the Petporte smart flap®will operate properly with your metal door.

How do I test my cat flap?

Press both buttons together. The cat flap is now in test mode. The red light will flash when it detects a microchip, and the green light will flash when it recognises your cat’s microchip. Remove the 4 screws on the front cover of the door, then remove the front cover.