Are King Springs any good for 4×4?
Kings Springs use high quality, high stress spring steel. Although considerably expensive, King Springs have introduced this new high stress steel to their passenger car and 4wd designs which benefit the most at no extra cost to the consumer. All King Springs heavy duty replacment springs are designed to be uprated.
Do King Springs sag?
Goods that are faulty, broken or have sagged will be replaced only once a valid claim has been lodged and accepted by King Springs. Consultation is required prior to returning goods under warranty.
Are King Springs made in Australia?
King Springs and V8 Supercars King Springs is Australia’s leading manufacture of springs for motorsport applications. On the world’s fastest racetracks, on the street, on the toughest outback terrain there is.
How long do King Springs take to settle?
Give it 2 months. And spend a day sitting in your boot jumping up and down. Sometimes the rear doesn’t have enough weight to settle properly. Give it 2 months.
How low is ultra low king springs?
Super Low Springs Lower Vehicle Approximately 10-20mm Lower Than Normal Low, Ultra Low Is A Further 10-20mm Again.
Where are King Springs made?
Queensland’s Gold Coast
King Springs are manufactured at our Head Office and Plant on Queensland’s Gold Coast. Our large, modern factory complex, comprising of 3 buildings spanning 8,000 square metres, has been purpose built from the ground up.
How long does it take for new coil springs to settle?
Normally about 500-1000 miles for the springs to settle. As stated above, all of the suspension parts should be torqued with the full weight of the car on them. Also, have your alignment checked after about 1000 miles.
Where are king springs manufactured?
What do raised springs do?
Raised Springs Raising your vehicle serves two main technical purposes: they raise the ride height and suspension travel of a vehicle, enabling it to tackle rougher terrain and provide more security for vehicles heading off-road and into deep water on a regular basis.
Which is lower super low or ultra low?
Ultra Low – Lowers vehicle approximately 10-20mm further from Super Low.
Why are coilovers better than springs?
Coilovers are a great alternative to a lowering spring set up because they allow you to adjust your ride height and come in many setups, from daily use to full track rated. Unlike lowering springs, you are not stuck with a single and stiffness.
Where can I buy King Springs in Australia?
Fulcrum Suspensions is one of the largest sellers of King Springs in the world, call us on 1800 385 278 . King Springs is Australia’s leading specialist manufacturer of aftermarket coil springs for world-wide, automotive applications.
Which coil springs for my 4×4 lift kit?
There is only one choice when it comes to coil springs for your 4×4, that’s why all our lift kits come with kings springs, with their huge range of standard and lifted springs, comfort to heavy duty, there is always a spring to suit. Front and Rear STD: Raises vehicle approximately 10mm-20mm above standard.
Where are King coil springs made?
King coil springs are manufactured to our specifications in the USA using the finest quality, high tensile, chrome silicon wire available. Our springs are specifically wound for off-road applications, not repackaged car springs.
How long do King coil springs last on 18 wheelers?
10. Special long wearing urethane seals have been tested on 18 wheelers for 450,000 miles without a u0003failure. 4. King coil springs are manufactured to our specifications in the USA using the finest quality, high tensile, chrome silicon wire available.