How do you connect a console to Riverbed?

Posted on by Emilia Duggan

How do you connect a console to Riverbed?

  1. To connect to the Management Console you must know the URL and administrator password that you assigned in the configuration wizard of the SteelHead.
  2. Specify the URL for the Management Console in the location box of your web browser:
  3. ://.

How do you connect Riverbed SteelHead?

  1. Plug the straight-through cable into the primary port of the SteelHead and the LAN switch.
  2. Identify the straight-through cable that connects your LAN switch to your WAN router.
  3. Plug the straight-through cable that you disconnected from the WAN router into the LAN port of the SteelHead.

How do I setup an IP address on riverbed?

Specify the following settings:

  1. IPv4 Address – Specify an IPv4 address.
  2. IPv4 Subnet Mask – Specify a subnet mask.
  3. Default IPv4 Gateway – Specify the primary gateway IP address. The primary gateway must be in the same network as the primary interface. You must set the primary gateway for in-path configurations.

When connecting a SteelHead appliance to a switch and router as shown what type of cables should be used?

End-users should use CAT-5E straight-through and cross-over cables to connect to their network in an in-path configuration. Make sure end-user uses the correct cables to establish their network connections: Straight-through cables? Primary and LAN ports on the appliance to the LAN switch.

What are the deployment modes for the Steelhead appliances?

Physical In-Path Deployments.

  • Virtual In-Path Deployments.
  • Out-of-Path Deployments.

    • What is Inpath interface in riverbed?

    In the Riverbed system, appliances have a unique in-path interface for each pair of LAN/WAN ports. For each appliance, the SCC detects LAN/WAN pairs, including those added through bypass cards, and identifies them according to slot (for example, inpath0_0, inpath0_1, inpath1_0, inpath1_1, and so on).

    How do I reset my steelhead?

    FIX:By default, reset factory will clear all the configuration except for the licenses and will halt the system. This behaviour can be changed with options appended to the command. These are: clear-licenses # reset factory clear-licenses Reset the system to factory defaults and clear all licenses.

    What are the deployment modes for the SteelHead appliances?

    What is fail to block in WAN optimizer?

    Fail-to-Block Mode. Some network interfaces support fail-to-block mode. In fail-to-block mode, if the SteelHead has an internal software failure or power loss, the SteelHead LAN and WAN interfaces power down and stop bridging traffic.

    What is Riverbed Inpath interface?

    What is Citrix Sdwan?

    Citrix SD-WAN is a core capability of the Citrix unified approach to Secure Access Service Edge (SASE) along with zero-trust network access and cloud-delivered security for secure, reliable access to all applications anywhere from any device.

    How does Citrix SD-wan work?

    Citrix SD-WAN enables standby links, which can be configured such that user traffic is only transmitted on a specific Internet WAN link when all other available WAN links are disabled. Standby links conserve bandwidth on links that are billed based on usage.