How do you reset service electronic throttle control manually?

How do you reset service electronic throttle control manually?

Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.

How do I reprogram my accelerator pedal position sensor?

Accelerator Pedal Release Position Learning Procedure. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.

How do I fix my electronic throttle control light?

solution: stop driving your vehicle and have it towed to your mechanic. there, the first step will be to scan the engine computer for a trouble code. this should point your mechanic in the right direction. if there is no code, then a check of the sensors, relays, and wiring in the system should identify the problem.

How do I reset my accelerator sensor?

To recalibrate the ECM and accelerator pedal, the ignition switch must be in the ON position and then the accelerator pedal must be slowly and fully depressed from idle to full throttle. Repeat the procedure three times.

How do you reset a pedal commander?

Resolution. Turn off your vehicle, wait for the ECU to shut off, then uninstall the Pedal Commander unit. After, reinstall your vehicle’s stock plugs and restart your vehicle. When check engine light clears, properly reinstall the Pedal Commander.

How do you reset throttle body after replacing?

How Do You Reset Throttle Body After Replacing? In a moment, hold the key to the “On” position again, wait another 3 seconds, and repeatedly press the accelerator. Hold the accelerator steady for 7 seconds.

Should you reset ECU after cleaning throttle body?

BTW its not necessary to reset the computer after doing a TB cleaning. I hope that helps! Your all off it sounds like you might have moved that throttle position sensor on the side of your throttle body, if you moved that it will make your idle go off and act like its going to cut off.