Is there a reset button on a Beachcomber hot tub?
Take off the hot tub cover to allow the water to cool down. You can reset by pushing any button once the heater cools down. Verify that the knife valve located on the heater’s return side is closed – once verified it’s closed, be sure all the knife valves are in the open or up position.
Why is my Beachcomber hot tub not heating up?
The problem could be due to a dirty spa filter. Remove the spa cartridge, clean the filters, and check the flow rate or pressure. Other causes could be a broken valve, clogged spa jets or pipes, or a broken pump impeller. You will notice this from an obvious reduced flow into your spa or hot tub.
How do I unlock my Beachcomber hot tub?
To unlock, press the pad, then the space between “warm” and “light” pads, then the pad within 2 seconds. The lock symbol will disappear and all panel pads will work again. For hot tubs with turbo option: Press , , within 3 seconds.
Why won’t my hot tub jets work?
Jets Are Not Working Properly When jets start failing, the most likely case is that your hot tub pump is not working correctly. Clogged filters or water intakes can also cause jet issues. Clean them to enhance water flow. If you cannot clean the filter properly, you may need to replace.
Where is the hot tub reset button?
Locate the spa’s high-limit reset. This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple.
Why is my hot tub control panel not working?
Bottom line is – it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
Why is my hot tub not getting hot?
If your spa heater won’t heat, remove and clean the filter(s) to rule out a pressure or flow rate problem in your hot tub heater. Low water level, a clogged pump impeller, closed valves, clogged pipes, or blocked spa drain covers can also cause flow issues.
Why is my hot tub not working?
Hot tub jets that are not working can be caused by air leaks, clogged drain covers, low water levels, dirty filters, bad pumps, improper jet adjustment, closed valves, electrical problems, clogged pump impeller, and issues with the hot tub controls. These issues should be troubleshot carefully.
How to troubleshoot a Beachcomber Hot Tub?
How to Troubleshoot Beachcomber Hot Tubs 1 Water Woes. If your Beachcomber’s water feels tepid, first make sure the tub is not in standby mode, which suspends all of the unit’s functions. 2 Pressure Problems. 3 Filter Fixes. 4 Beyond the Basics.
How do I contact Beachcomber’s customer care?
Contact Beachcomber’s customer care department at 1-800-663-6557 or 604-591-8611 for problems of this nature. When purchased new, Beachcomber’s warranty covers factory-installed hot tub components for two years, acrylic shell surfaces for five years and the tub’s shell structure for a lifetime.
How do I Activate my Beachcomber guarantee?
Register online in order to activate your Beachcomber Guarantee: www.beachcomberhottubs.com/register Online registration must be completed within 30 days of hot tub delivery. Before you go online, ensure you have two things: 1. A scanned copy or photo of the Beachcomber Hot Tub Setup and Install Checklist.
What are Beachcomber’s safety guidelines?
• Always follow the label instructions and warnings on Beachcomber water care chemical bottles. • Prevent unauthorized child access to avoid the risk of drowning. • When shock treating hot tub water, leave the cover slightly open to allow vapor to escape for 1 hour.
https://www.youtube.com/watch?v=HQ6-d1WBCUs