What is APC network card?

What is APC network card?

APC UPS Network Management Cards allow for secure monitoring and control of an individual APC UPS via web browser, command line interface, or SNMP. The configurable notification features keep you informed of problems as they occur.

How do I network APC UPS?

Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.

1. Apply the port settings to establish the connection.
2. Press enter 3-5 times to display the username prompt.
3. Use the default username and password of “apc”.

What is a UPS for network?

An uninterruptible power supply (UPS) is a device that allows a computer to keep running for at least a short time when the primary power source is lost. UPS devices also provide protection from power surges.

How do I reset my AP9630?

Hold the reset button for 5-7 seconds. Resets only the password. Hold the reset button for 20 seconds. This will restore the card to factory default settings including switching back to DHCP mode.

How do I find my APC UPS IP address?

On the LCD menu, access the About menu. On the About menu, select the SmartSlot Card option. Locate and access the IP address option. In our example, the LCD menu shows the APC UPS IP address 10.10.

How do I assign an IP address to APC UPS?

Tutorial APC UPS – Initial IP address configuration

1. • Configuration > Network > TCP/IP > IPV4 Settings.
2. Configure the desired static IP address an click on the Apply button.
3. After finishing the IP address configuration, you need to restart the network management interface for the new IP address to be accepted.

How do I set up UPS?

Configuring the UPS Settings

1. Connect the UPS to the NAS using a USB cable.
2. Select USB connection.
3. Choose one of the following options.
4. (Optional) Select Enable network UPS master and then specify the IP addresses to which QTS sends notifications in the event of power failure.